Filter
Top Products
http://www.tyan.com
58
3.3.7 Remote Access Configuration
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
Configure Remote Access type and parameters
Remote Access
Serial Port Number
Base Address, IRQ
Serial Port Mode
Flow Control
Redirection After BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
Sredir Memory Display Delay
[Disabled]
[COM1]
[3F8h, 4]
[38400 8, n, 1]
[None]
[Always]
[ANSI]
[Enabled]
[No Delay]
Select remote access
type.
← Select Screen
↑↓ Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
Remote Access
Enables remote access to system through serial port.
Disabled / Enabled
NOTE:
The following BIOS items are available only when Remove Access is set
to [Enabled].
Serial Port Number
Select Serial Port for cosole redirection. Make sure the selected port is enabled.
COM1 / COM2
Serial Port Mode
Select Serial Port settings.
Flow Control
Select Flow Control for console redirection.
None / Hardware / Software
Redirection After BIOS POST
Disabled: Turns off the redirection after POST Boot Loader.
Boot Loader: Redirection is active during POST and during Boot Loader.
Always: Redirection is always active. (Some Oss may not work if set to Always)
Always / Disabled / Boot Loader
Terminal Type
Select the target terminal type.
ANSI / VT100 / VT-UTF8