Filter
Top Products
24
Operation display LED contents
and the LCD panel
For details, see p. 46 – 47 of this manual.
Initialization period
When the power is turned on, the printer performs
positioning of the ink ribbon and retransfer film. It also
initializes the mechanisms of the printer and check their
operations. “Initializing” is displayed on the LCD panel
during this period.
Preheating period
When the initialization of the mechanisms completes
normally, the printer increases the temperature of the
retransfer roller and bend remedial roller up to the
specified levels. “Preheating” is displayed on the LCD
panel during this period.
LCD operation display content
Printer status
Mechanism set
period
Preheat period
Ready period
Printer operation
period
Error occur
User mode
READY ERROR LCD panel
Initializing..
Preheating..
Ready
When an error
occurs
*Depends on the
error content
Depends on the
user mode content
or
: LED on
: LED off
Preheating..
Loading..
Printing..
Encoding..
Retransfer..
Unloading..
Cleaning..
Sleeping..
USB Ready
xxxxx
xxxxx
xxxxx
xxxxx
xxxxx
xxxxx
xxxxx
Heating..
xxxxx
NET Ready
Getting IP
OS booting up
* Firmware version
Shows firmware
version number.
Displayed during the
initialization
process.
Displayed during
preheating
* Displays Total/Head/Free or
Roller(Display is Roll.),
according to the counter
select setting.
Displayed during
feeding
Ready status
(USB connection)
* Print counter
Displayed during
printing
Displayed during
encoding
Displayed during
retransfer
Displayed when cards
are discharged from the
NG card outlet
Displayed during
cleaning operations
When the heater
status is OFF
because of the power
save function
Before use (continued)
Displayed during
adjusting the
temperature for
setting value
Memo
Initializing..
Boot Up..
xxxxxxx
Ver. xxx/xx/xx
INT Complete
xxxxx
Ready status
(LAN connection)
Getting IP address
(In case of DHCP
ON)
Network adress
When the heat roller temperature setting has been
changeed or after setting the Low temperature
stand-by mode.HEATING will be displayed if the
configured temperature does not match the actual
temperature before the retransfer operation starts.