Filter
Top Products
40
Care and cleaning
Always make sure that the printer is turned off before cleaning.
(However, cleaning of the card feed rollers and magnetic head should be carried out with the power turned on.)
To achieve the best performance from the printer, always check each part before use for dust and dirt and clean if necessary.
The following explains the main rollers that require cleaning. For details about other rollers, see p.45 (Internal roller layout).
Dust and dirt, particularly on the thermal head, rollers and cleaning rollers can cause print blurs and shifting of colors.
Cleaning the cleaning rollers
The cleaning rollers remove dust and dirt sticking to the card.
Cleaning the cleaning rollers after every use is recommended
if the printer is used almost everyday. Depending on the
cards, there may be much dust and dirt. In such a case,
perform cleaning every 100 to 200 cards. Do not do this,
however, during printing operations.
1. Open the card tray.
2. Remove the cleaning unit.
Pull out the cleaning unit toward you as shown in the
illustration below.
3. Wash the rollers of the cleaning unit with water.
Wash out dirt on the roller surface with your fingers.
Do not use alcohol or detergents. The cleaning unit
should be cleaned only with running water.
4. Push the cleaning unit back into the printer.
Push the cleaning unit with the rollers facing upward
until it is securely back into the place.
5. Close the card tray.
After washing the cleaning unit with
water, wait until it completely dries up and set it in the
printer.
CAUTION
Deteriorated cleaning rollers may
cause defects in the printed card. If the rollers begin to
deteriorate, replace the cleaning unit.
(We recommend replacement after a year)
CAUTION
When you remove the cleaning unit,
be careful not to injure your fingers by inner mechanism.
CAUTION