Filter
Top Products
5. To scroll repeatedly, press and hold or and
.
After 3 seconds, the scanner will begin to scan
through the Police frequencies (Police only).
6. If you want to start scanning immediately, press
.
1. When scanning stops on a desired frequency, press
to hold at that frequency as long as
you like.
While appears in this mode, you can use
or to move up or down the frequency steps.
During Hold mode, you can see all frequencies
sequentially. It does not depend on your selected
bank.
Pressing and holding the keys for 1 sec, speeds up
frequency change.
If present frequency is locked out, then appears
on LCD.
You can quickly store any frequency you find during scan.
1. During scan, press to store.
You can press or to move up or down 1 frequency step.
2. If you have found the frequency you want to store, press .
3. Select the private bank where you want to store the frequency, the smallest empty
channel number and "000.0000" flashes on and off over the frequency you want to store.
Press (if the frequency you want to store exists already in a bank, you will hear an error
tone and the other channel displays. Press again to store the frequency in both
channels).
To skip a frequency, press . You can program up to 100 skip frequencies.
You can skip the frequencies in the scanning sequence.
If you change the state code, skipped frequencies are canceled as soon as scanning starts.
If you change the State, skip frequencies are all clear.
STATE
HOLD/RESUME
HOLD/RESUME
”HOLD”
”L/O”
HOLD/RESUME
E
E
E
L/O
State Scan Hold
Storing State Scan Frequencies
Skip a frequency
2. To resume scanning, press .HOLD/RESUME
- Or-
When the scanner stops on the frequency you want to store, press .E