Filter
Top Products
Hold/Resume
Channel Lockout
Restoring a Locked-out Channel in Hold Mode
If you want to stop on a channel during scanning, press
If you want to resume scanning, press
There are several ways to access a specific channel quickly.
1. Press
2. Using the keypad, enter the channel number.
3. Press again.
You can also use the SCAN, or key instead of
pressing
You can lockout any channel so it is not checked during normal scanning. You can also
restore the channel to scanning when you wish.
1. Press and enter the channel number by using the keypad, then press
––– OR –––
1. Press and select the channel by using the
or key.
2. Press to lockout the channel.
appears on the display.
If the scanner keeps stopping on a particular channel due to noise or frequent transmissions,
you may want to keep that channel from scanning.
1. Wait until the scanner stops on the channel.
2. Then press
3. The scanner immediately resumes scanning because the locked out channel is no
longer in the scanning sequence.
Write down your locked-out channels and put in a convenient place in
case you need to restore them.
1. Press and select the channel number you want to restore by using the
keypad, the or key, then press
2. Press to unlock the channel. The “ ” disappears.
HOLD/RESUME.
HOLD/RESUME.
Direct channel access:
HOLD/RESUME.
HOLD/RESUME
Note:
HOLD/RESUME.
Lockout in Hold Mode
HOLD/RESUME
HOLD/RESUME.
HOLD/RESUME
L/O
“L/O”
Lockout in Scanning Mode
L/O.
Lockout Tips
HOLD/RESUME
HOLD/RESUME.
L/O L/O
SCAN
SCAN
SCAN
SCAN