Filter
Top Products
If you experience difficulty while in TrunkTracker mode, try the following steps.
If you still cannot get satisfactory results while using your scanner or if you want additional
information,
If you have internet access, you can visit for
additional information.
please see the Uniden contact details in the warranty page at the back of this
manual.
www.uniden.com.au, www.uniden.co.nz
Problem Suggestion
1. Missing the Data Frequency.
2. Change to a Type 1 Scanner setup.
Review Fleet Map Programming on page 44.
1. No IDs have been programmed.
2. The IDs you have stored are not active.
1. Adjust the squelch for Trunking mode - refer to page 29.
2. Missing the frequency used for the data channel.
Check your frequency list.
1. Change a Type 1 scanner setup.
Review Fleet Map Programming on page 44.
2. Try another Preset Fleet Map or Program your own Fleet
Map.
3. Check to see that all of the system's frequencies have
been entered.
1. May be a telephone interconnect call, which are
intentionally blocked by your scanner.
2. The ID on your display is not active.
1. Logical channel numbers (frequencies) for the system are
not programmed in the correct order. Check frequency
resources and reprogram.
2. Not all frequencies for the system are programmed.
Check frequency resources.
Scanner won't track.
Scanner won't stop
during Scan List mode.
Scanner will not acquire
data channel.
Missing replies to
conversations.
Channel Activity
Indicators are flashing
but no sound is heard.
Scanner not tracking an
EDACS system
properly.