Filter
Top Products
Remote Interface
You can communicate and program your UBCT8 in numerous ways with peripheral devices
using a Remote Interface Cable port. This radio offers the following modes:
Program and control your scanner from a PC using Uniden’s UBCT8 Scanner Software.
Clone all the frequencies, trunking talkgroups, and fleet maps programmed into your
scanner to another UBCT8 scanner or another UBCT8.
!
!
PC Control mode
Clone mode
To connect Scanner to PC:
PC Control Mode
Plug the scanner end of the RS232C straight cable into the remote port which is on the rear
of the scanner. Plug the other end of the cable (DB-9 serial connector) into a personal
computer’s serial port. A few PC’s may require an adapter, most will not. Of course, make
sure your PC is turned ON.
You can program and control your scanner remotely from a PC using Uniden’s UBCT8
Scanner software.
After connecting the scanner to a PC, turn the scanner ON.
To use the Remote (PC Control) mode, you must install Uniden’s UBCT8 Scanner software
and use as directed. Make sure that your scanner is connected to the serial port of the PC
using the RS232C straight cable.
To program your scanner: