Filter
Top Products
Installation
Vidikron Vision 30 Series Owner’s Operating Manual 21
PRE
L
IMINAR
Y
3.5
Installing the Optional
CineWide Lens Mount
If you are installing a Vision 30/CineWide, proceed as follows to install the CineWide
anamorphic lens base plate.
To install the fixed CineWide base plate on a Vision 30/CineWide:
1. Place the projector upside down on a blanket or other soft surface.
2. If you are mounting the Vision 30/CineWide on a ceiling:
a Line up the four holes on the projector ceiling mounting plate (included with the
projector ceiling mount kit) with those on the bottom of the projector.
b Line up the two mounting holes on the CineWide base plate with those at the front of
the ceiling mounting plate.
3. Secure the CineWide base plate (and ceiling mounting plate, if needed) to the projector
with the required number of M6 x 1.0mm x 16mm screws: two for the lens base plate
only, or four for the base plate and ceiling mounting plate. See
Figure 3-4. TIGHTEN THE
SCREWS SECURELY, BUT DO NOT OVER-TIGHTEN THEM.
4. If you are mounting the Vision 30/CineWide on a ceiling: Complete the ceiling mount
installation procedure given in the instructions provided with the ceiling mount kit.
Figure 3-4. Vision 30/CineWide with Anamorphic Lens Base Plate and Ceiling Mounting
Plate - Bottom View
1. Do not install the CineWide lens yet, only the fixed CineWide base
plate. You will install the CineWide lens after you install the projector
and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
Note
Vision 30/CineWide with Ceiling Mounting
Plate
Vision 30/CineWide with Ceiling Mounting
Plate and Lens Base Plate