Filter
Top Products
19
Powering On the Projector
1. Securely connect the power cord and signal cable. Power on the switch 1 and
the Power LED ashes Blue.
2. Turn on the lamp by pressing the “
” button either on the control panel of the
projector or on the remote control
2. The Power LED will turn blue.
The startup screen will display in approximately 10 seconds. The rst time you
use the projector, you will be asked to select the preferred language and power
saving mode.
3. Turn on and connect the source that you want to display on the screen
(computer, notebook, video player, etc). The projector will detect the source
automatically. If not, push the menu button and go to “OPTIONS”.
Make sure that “Auto Source” has been set to “Off”.
` If you connect multiple sources at the same time, press the direct source
buttons on the control panel or on the remote control to switch between
inputs.
Powering On/Off the Projector
1
Source
Sync
Shift
Pattern
VGA
BNC
Sync
Standby
HDMI
DVI
Source
Video
S-Video
Blank
Vol +
Vol -
Exit Mute
Menu Memory
Focus ShiftZoom
Lamp PW
Mode
RGB Gain
PIP
BlendGeo
MyButton
Aspect
Keystone
RC ID
Reset
123
456
789
0
LENS
Power On
2
Turn on the projector rst and then select the signal sources.