Filter
Top Products
20
Powering Off the Projector
1. Press the “Standby” button on the remote control or the “ ” button on the con-
trol panel to turn off the projector
1. The following message will be displayed on
the screen.
Press the “Standby” button on the remote control or the “ ” button on the
control panel again 1 to conrm otherwise the message will disappear after 15
seconds. When you press for the second time, the projector will shut down.
2. The cooling fans will complete the cooling cycle for about 60 seconds and the
POWER LED will ash Blue. The projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered standby mode. Once in standby
mode, simply press the “
” button either on the control panel of the projector
or on the remote control to restart the projector. 2
3. Power off the switch
3.
4. Disconnect the power cord from the electrical outlet and from the projector.
3
Source
Sync
Shift
Pattern
VGA
BNC
Sync
Standby
HDMI
DVI
Source
Video
S-Video
Blank
Vol +
Vol -
Exit Mute
Menu Memory
Focus ShiftZoom
Lamp PW
Mode
RGB Gain
PIP
BlendGeo
MyButton
Aspect
Keystone
RC ID
Reset
123
456
789
0
LENS
Power On
1
2
Do not turn on the projector immediately following the power of procedure.