Filter
Top Products
31 ViewSonic PJ510
Replacing The Lamp
If the indicators or a message prompts you to replace the lamp, replace the lamp as soon as possible.
Using the lamp for long periods of time, or past the replacement date, could cause it to burst. If the
projector is mounted on the ceiling, or if the lamp has broken, do not try to clean the projector or
replace the lamp yourself.
1 Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at least 45
minutes.
2 Contact your local dealer to prepare a new lamp. Tell the dealer your lamp type number. If the
projector is mounted on the ceiling, or if the lamp has broken, also ask the dealer to replace the
lamp.
In the case of replacement by yourself,
3 After making sure that the projector has cooled adequately, slowly flip over the
projector, so that the bottom is facing up.
4 Hold the release button while sliding out the lamp cover.
5 Unscrew the 2 screws, and slowly pick up the lamp
by the handles.
6 Insert the new lamp, and tighten the 2 screws
firmly to lock it in place.
7 Slide the lamp cover into place until it locks into position.
8 Slowly turn the projector so that the top is facing up.
9 Turn on the projector, and reset the lamp timer.
(1) While the projector running, press the MENU button
to open the menu.
(2) Choose the “OPTION” on the menu using the (S)/(T) button, then press the (X) button or
ENTER button
(3) Choose the “LAMP TIME” using the (S)/(T) button, then press and hold the (X) button of
projector or the RESET button of remote control for 3 seconds.
(4) Choose the “RESET” using the (S) button.
CAUTION
• Do not reset the lamp timer without replacing the lamp.
• When you replace the lamp, please replace also the air filter. The air filter may be attached when
you buy a replacement lamp for this projector. Please ask your dealer.
Lamp cover
Release button
Handles
Screws