Filter
Top Products
ViewSonic PJ510 32
Air Filter
Caring For The Air Filter
The air filter should be cleaned about every 100 hours. If the indicators or a message prompts you to
clean the air filter, clean the air filter as soon as possible. If the air filter becomes clogged by dust or
the like, internal temperature rises and could cause malfunction.
1 Turn off the projector, and unplug the power cord.
2 Apply a vacuum cleaner to the top of the filter cover to clean
the air filter.
3 Reset the filter timer, according to following “Reset The
Filter Timer”.
(1) Turn on the projector. While the projector running, press the MENU button to open the menu.
(2) Choose the “OPTION” on the menu using the (S)/(T) button, then press the (X) button or
ENTER button.
(3) Choose the “FILTER TIME” using the (S)/(T) button, then press and hold the (X) button of
projector or the RESET button of remote control for 3 seconds.
(4) Choose the “RESET” using the (S) button.
WARNING
• Please carefully read the “PJ510 QUICK START GUIDE”.
• Before replacing the air filter, make sure the power switch is off and the power cable is not
plugged in.
• Use the air filter of the specified type only. (sold separately)
• Do not use the projector with the air filter and filter cover removed. The use without the air
filter could result in damage.
CAUTION
• Do not reset the filter timer without cleaning or replacing the air filter.
• If the air filter becomes clogged by dust or the like, internal temperature rises and could cause
malfunction. The power is automatically turned off in order to prevent the projector from
overheating internally.
• When you replace the lamp, please replace also the air filter. The air filter may be attached when
you buy a replacement lamp for this projector. Please ask your dealer.
Filter cover