Filter
Top Products
OPTION Menu
OPTION Menu
Item Description
AUTO SEARCH
Using the buttons ▲/▼ turns on/off the automatic signal search func-
tion.
TURN ON
TURN OFF
When the TURN ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from the
current port. Then when an input is found, the projector will stop searching
and display the image.
RGB IN1
RGB IN2
COMPONENT VIDEO
S-VIDEO
VIDEO
AUTO KEY-
STONE
Using the buttons ▲/▼ turns on/off the automatic keystone function.
TURN ON
TURN OFF
TURN ON : Automatic keystone distortion correction will be execut
-
ed whenever changing the slant of the projector.
TURN OFF : This function is disabled. Please execute the AUTO
KEYSTONE EXECUTE in the SETUP Menu for automatic keystone
distortion correction.
When the projector is suspended from the ceiling this feature will
not function properly so select TURN OFF.
This function will be unavailable when Transition Detector is on.
AUTO ON
Using the buttons ▲/▼ turns on/off the AUTO ON function.
TURN ON
TURN OFF
When set to TURN ON, the lamp will only be automatically turned on when
the Power switch is turned on after the power was turned off by Power
switch last time.
The lamp will not be automatically turned on when the Power switch is
turned on if the lamp was turned off with the following procedures.
• The lamp was turned off with a remote control, projector button, or
power turn off command.
• The lamp was turned off with an AUTO OFF function.
• The lamp was turned on by an AUTO ON function and was turned
off about 30 minutes after no signal had been detected.
When no input is detected after the power on and AUTO OFF time is set to 0,
the projector will be turned off after about 30 minutes passed.
When no input is detected after the power on and AUTO OFF time is set to
1 to 99, the projector will be turned off after the passed time reaches at the
set time.
If one of the projector’s buttons or the remote control buttons is pressed
or one of the commands (except get commands) is transmitted from the
control port during the corresponding time, projector will not be turned off.
With the OPTION menu, the items shown in the table below can
be performed.
Select an item using the cursor buttons ▲/▼ on the projector or
remote control, and press the cursor button ► on the projector
or remote control, or the ENTER button on the remote control to
execute the item, except for the items LAMP TIME and FILTER
TIME. T
hen perform it referring to the following table.
MENU [RGB1]
PICTURE
:SELECT
IMAGE
SETUP
INPUT
OPTION
EASY MENU
SCREEN
AUTO OFF 0min
LAMP TIME 0h
FILTER TIME 0h
AUTO SEARCH TURN OFF
AUTO KEYSTONE TURN OFF
AUTO ON TURN OFF
MY BUTTON
SERVICE
40ViewSonic PJ658