Filter
Top Products
Item Description
SECURITY
4. Using the Transition Detector Function
While the Transition Detector function is ON, when power switch is started to
supply to the projector, it might react as below.
• Transition Detector alarm shown below might appear on screen, if the pro-
jector has been moved or re-installed.
• Transition Detector alarm might appear on screen, if the MIRROR setting
has been changed.
• Keystone adjustment feature has been prohibited as long as the Transition
Detector function is ON.
4.1 Turning On the
Transition Detector
Function
4.1-1
Use the ▲/▼ buttons on the SECURITY menu to
select Transition Detector and press the ► or the
ENTER button to display the Transition Detector
on/off menu. Select TURN ON and the current
angle, mirror and keystone setting will be recorded.
NOTE: This feature may not function properly if the projector
is not in a stable position when TURN ON is selected.
4.1-2
If this function is set to TURN ON when the
vertical angle of the projector, mirror or key-
stone setting at which the projector is turned
on is different than the previously recorded the
Transition Detector Alarm will be displayed and
the projector will not display the input signal.
Either set the Transition Detector off in the SECURITY menu or set the projector at
the recorded angle, mirror and keystone setting to display the input signal.
If the Transition Detector ALARM is displayed for about 5 minutes the lamp will turn off.
This function will activate only when the projector is started after the power
switch was turned off.
4.2 Setting the
Transition Detector
PASSWORD
4.2-1
Use the ▲/▼ buttons on the SECURITY menu to select
Transition
Detector
and press the ► or the ENTER button to display the
Transition
Detector
on/off menu.
4.2-2
Use the ▲/▼ buttons on the Transition Detector
on/off menu to select TURN ON. The ENTER
PASSWORD BOX (small) will be displayed.
4.2-3
Use the ▲/▼/◄/► buttons to enter a PASSWORD.
Move the cursor to the right side of the ENTER
PASSWORD BOX (small) and press the ► button
to display the CHECK PASSWORD BOX, enter the
same PASSWORD again.
4.2-4
Move the cursor to the right side of the CHECK
PASSWORD BOX and press the ► button to
display the PASSWORD for about 20 seconds,
please make note of the PASSWORD during
this time. After the PASSWORD has displayed
for about 20 seconds the screen will return to
the Transition Detector on/off menu.
Pressing the ENTER button on the remote controll or the INPUT button on
the projector will close the PASSWORD BOX.
NOTE : Please do not forget your Transition Detector PASSWORD.
OPTION Menu (continued)
OPTION Menu
Transition Detector
on/off menu
Transition Detector
Alarm
ENTER PASSWORD
BOX (small)
CHECK PASSWORD
BOX
PASSWORD BOX
48ViewSonic PJ658