Filter
Top Products
DLP Projector—User’s Manual
— 48 —
LED Error Messages
POWER LED TEMP LED LAMP LED
ERROR CODE MESSAGES
BLUE RED RED RED
Lamp Ready ON
－ － －
Start
－
flashing
－ －
Cooling
－
flashing
－ －
Over Temperature
－ －
ON
－
Thermal Break Sensor error
－ － －
4 blinks
Lamp Error
－
5 blinks
－ －
Burner Fan error
－
6 blinks 1 blinks
－
System Fan error
－
6 blinks 2 blinks
－
Power and Ballast Fan error
－
5 blinks
－
1 blinks
Case Open
－
7 blinks
－ －
DMD error
－
8 blinks
－ －
Color wheel error
－
9 blinks
－ －
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the Power or Lamp LEDs are still blinking or the Temp LED is lit, contact your
service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control or projector.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Display Setings menu of the OSD.
Problem: The image is streaked
1. Set the Frequency settings on the Image Settings>Advanced menu of the OSD to the
default settings.
2. To ensure the problem is not caused by a connected PC’s video card, connect to another
computer.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the Image menu of the OSD.
Problem: The color of the projected image does not match the source image.