Filter
Top Products
Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management
13
Configuring the Switch
A quick list of frequent configuration tasks and their locations is shown here. More
detailed information on each configuration task follows the table. Once you reach the
location, you may need to click Change Settings and/or other links or buttons before
configuration parameters are available for changing.
Note: To configure switch
settings, you must be
logged into the Web
Manager.
General switch status is shown on the Home page (click Home). You can click the
options at the top of the page to view additional information and configure the switch.
These options are discussed in more detail on the following pages.
Resetting the Switch
Changes to certain switch settings require you to reset the switch for those changes to
occur. You must be logged into the Web Manager to reset the switch.
To reset the switch, click Reset Switch on the Home page.
Configuration Task Location in Web Manager
Change the switch speed
(See “Switch Speed” on page 16.)
System > Change Settings
Change device identification, contact, and
location
(See “Switch Identification” on page 16.)
System > Change Settings
Upgrade firmware
(See “Firmware Settings” on page 18.)
System > Firmware
(click Load New Firmware Image)
Change the network settings (IP Address,
Gateway, and Netmask)
(See “Network Settings” on page 15.)
System > Change Settings
Change the time settings
(See “Time Settings” on page 17.)
System > Time > Change Time Settings
Configure zoning
(See “Zone Settings” on page 31.)
Zoning
View & download event log
(See “Event Log Messages” on page 19.)
System > Event Log
Reset switch
(See “Resetting the Switch” on page 13.)
Home (click Reset Switch)
View & update policies
(See “Policy Settings” on page 29.)
Policy