Filter
Top Products
Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management
37
Configuring the Switch
The CLI enables you to configure the switch settings, policies, and zoning.
A list of frequent switch configuration tasks and their commands is shown here. Refer to
the provided page number for more detailed information on each configuration task.
To view the complete list of available switch commands while using the CLI, type ? or h
at the prompt. For a complete listing of all CLI commands, see CLI C
ONSOLE
C
OMMANDS (APPENDIX B) on page 60.
Configuration Task CLI Command
Change the IP parameters
(See “Changing the Switch’s IP Parameters” on page 38.)
co
Change switch identification, contact, location, etc.
(See “Configuring Switch Information” on page 38.)
si
Upgrade firmware
(See “Managing the Firmware” on page 39.)
fw
Add or delete a trap destination (through the
Configuration menu)
(See “Configuring the Trap Destination Table” on page 41.)
ct
Changing the password
pw
View switch management, policies, error thresholds, and
other switch settings.
(See “Viewing Management, Policy, and Threshold Settings” on
page 43.)
mc
Change the switching mode
(See “Changing the Switching Mode” on page 47.)
sw
Configure zoning
(See “Viewing and Understanding Zoning Information” on
page 52.)
oz
(for overlapping zoning)
noz
(for non-overlapping zoning)
Reset switch
(See “Resetting the Switch” on page 13.)
rs
Reset switch to factory default settings
(See “Resetting the Switch to Factory Default Settings” on
page 51.)
rc
View & modify port settings
(See “Displaying Ports” on page 49.)
po
Change the switch speed
(See “Changing the Switch’s Operating Speed” on page 52.)
lsp
View the event log
(See “Viewing the Event Log” on page 51.)
ev