Filter
Top Products
5-18
APS-8M / APS-16M Asynchronous Port Switches; User’s Guide
5.6. Copying Parameters to All Ports
The /CP command (Copy Port Parameters) provides a convenient means for
selecting similar parameters for all APS-8/16M RS232 ports.
When the /CP command is invoked, the unit will display a menu which allows
you to select port communication parameters, then copy them to all
APS-8/16M RS232 ports. The Copy Port Parameters menu can be used to set
all parameters for all RS-232 Ports, or define only a select group of parameters
and then copy them to all ports.
Notes:
• The /CP command is only available in Supervisor Mode.
• The /CP command cannot be used to set Ports 1 and 2 to Passive
Mode or Buffer Mode (Port Mode, Item 6.)
• The /CP command cannot be used to disable the Supervisor Mode at
Ports 1 and 2 (Supervisor Mode, Item 7.)
• The /CP command cannot be used to change the Port Mode for
the Internal Modem Port. The Internal Modem Port is always
configured for Modem Mode.
COPY PORT PARAMETERS:
1. Port Name:
2. Baud Rate:
3. Bits/Parity:
4. Stop Bits:
5. Handshake Mode:
6. Port Mode:
64. DTR Output:
7. Supervisor Mode:
8. Logoff Character:
9. Sequence Disconnect:
10. Timeout Disconnect:
11. Response Type:
12. Command Echo:
13. Accept Break:
14. Invalid Access Lockout:
(Note: ports 1 & 2 will NOT have restricted values changed.)
Enter: parameter # <CR> to define parameter value to copy to all ports,
-<CR> to remove all values set,
X<CR> to exit WITHOUT copy,
<ESC> to copy to ports and exit ...
Figure 5.7: The Copy Port Parameters Menu