Filter
Top Products
11-5
Command Reference Guide
/C Connect
Establishes a bidirectional connection between two ports. For more
information and command line examples, please refer to Section 8.1. There
are two types of port connections:
• Resident Connect: If the /C command specifies one port name or
number, your resident port will be connected to the specified port.
• Third Party Connect: If the /C command specifies two port names or
numbers, the unit will connect the two ports indicated. A Third Party
Connect command must be issued from a third port where Supervisor
Mode is active. Passwords and ports that do not permit Supervisor Mode
cannot initiate a Third Party Connect.
Note:
• Passwords and ports that do not permit Supervisor Mode can only
connect to the ports that are specifically allowed by the password
entered at log in.
• Passwords and ports that permit Supervisor Mode can connect to
any free APS-8/16M port.
Availability: Supervisor Mode / Non-Supervisor Mode
Format: /C <x> [x] [Enter]
Where x is the number or name of the port(s) to be connected.
Response:
Verbose: Connected xx, when a Resident Connection is initiated, the
APS-8/16M will also display the currently selected Resident Disconnect
Sequence for your port.
Terse: 1
/CP Copy RS232 Port Parameters
Allows quick set-up when all RS232 ports will be configured with the same or
similar parameters. When the /CP command is invoked, the APS-8/16M will
display a menu that is used to select common port parameters, which can then
be copied to all APS-8/16M RS232 ports. Note that the Copy Command will
not change restricted parameters at Ports 1 and 2 or the Internal Modem Port.
For more information, please refer to Section 5.6.
Availability: Supervisor Mode Only
Format: /CP [Enter]
Response: Displays Copy Parameters Menu