Filter
Top Products
7-4
APS-8M / APS-16M Asynchronous Port Switches; User’s Guide
7.3. The Port Parameters Screens (/W)
The /W command displays more detailed information about an individual
APS-8/16M port. Rather than listing connection information for all ports like
the Port Status Screens, the Port Parameters screen lists all defined parameters
for a specific port as shown in Figure 7.3.
The /W command is available to both Supervisor Mode and Non-Supervisor
Mode ports and passwords. Note however, that if the /W command is invoked
by a port or password that does not permit access to Supervisor Mode, then the
APS-8/16M will only display information for your resident port.
7.4. The Password Directory Screen (/V)
The Password Directory Screen (Figure 7.4) lists currently defined parameters
for each of the APS-8/16M passwords. Note that the Password Directory
screen will not display actual passwords, and instead, will only indicate
whether or not a password has been defined for each username.
The Password Directory Screen is only available when the Supervisor Mode
is active, and cannot be displayed by ports or passwords that do not permit
Supervisor Access. The APS-8/16M allows for the definition of up to 32
separate passwords.
PORT PARAMETERS #01:
1. Port Name: (undefined)
2. Baud Rate: 9600
3. Bits/Parity: 8-None
4. Stop Bits: 1
5. Handshake Mode: RTS/CTS
6. Port Mode: Any-to-Any
64. DTR Output: Pulse
7. Supervisor Mode: Permit
8. Logoff Character: ^X
9. Sequence Disconnect: One Character Only
10. Timeout Disconnect: Off
11. Response Type: Verbose
12. Command Echo: On
13. Accept Break: Yes
14. Invalid Access Lockout: Off
APS>
Figure 7.3: The Port Parameters Screen (Port 1 Shown)