Filter
Top Products
14
Configuring the Intelligent Gateway on Macintosh computers
Refer to the “Welcome Letter” that was included in you Intelligent Gateway package. It provides the key
code you will need to configure the Intelligent Gateway on your Macintosh computer.
Macintosh 8.6 and 9.x
1. Click the Apple menu and select Control
Panel>TCP/IP
. The TCP/IP menu opens.
2. From the Connect via dropdown, select the
method by which the Intelligent Gateway will
connect to your computer (Ethernet, PC Port,
or wireless).
3. From the Configure dropdown, select Using
DHCP Server
.
4. Exit the TCP/IP menu. Click Yes when
prompted to save changes.
5. After the software installation is complete,
your Intelligent Gateway is ready to use ADSL service and the
POWER, LOCAL NETWORK, and
BROADBAND LINK LEDs should be green.
Note: Refer to the “Using the Intelligent Gateway Network” chapter for information about the computers
on your network.
Macintosh OS X
1. Click the Apple menu and select System Preference>Network.
2. From the Show dropdown, select the method by which the Intelligent Gateway will connect to your
computer (Built-in Ethernet, PC Port, or wireless).
3. Click the TCP/IP tab.
4. From the Configure dropdown, select Using
DHCP
.
5. Click Apply Now.
6. After the software installation is complete, your
Intelligent Gateway is ready to use ADSL
service and the
POWER, LOCAL NETWORK,
and
BROADBAND LINK LEDs should be
green.
Note: Refer to the “Using the Intelligent Gateway
Network” chapter for information about the
computers on your network.