Filter
Top Products
DSC AND SCS DATA STREAM COMMANDS
Bell (BEL)
2F
Turns on the attention indicator to show that operator action is
required and sounds the alarm if it is not disabled. The printer
stops and waits for operator attention. (This command is
currently accepted but ignored.)
2F Control sequence of a Bell command
Carriage Return (CR)
0D
Moves the print position to the first position on the same line. If
already at the first position, this command is ignored. The print
position is moved to the effective left margin of those printers
which support the Set Horizontal Margin command.
0D Control sequence of a Carriage Return command
Enable Print (ENP)
14
This command is used in conjunction with the Inhibit Print (INP)
command. Any printable characters between INP and Enable
Print (ENP) commands are translated to spaces. SCS control
codes between INP and ENP can cause unpredictable results.
N Note: Only the 4245 emulation carries out the actions described
above; all other emulations ignore this command.
14 Control sequence of an Enable Print command
Form Feed (FF)
0C
Moves the print position to the top line and left margin of the
next form as specified by the Set Vertical Format (SVF) command.
If this is not specified by the SVF command, the maximum print
line is assumed to be one and the print position moves to the
left margin of the next line.
0C Hexadecimal (HEX) value of a Form Feed
command
2-8 XEROX MRP FAMILY COAX COMMAND REFERENCE