Filter
Top Products
DSC AND SCS DATA STREAM COMMANDS
starting in line 4, you must enter four VCS commands.
Unprintable characters appear on the paper as spaces.
There are two different 3268 and 4214 emulations. When using
the first 3268 and 4214 emulations, the system sends the number
of Line Feed commands required by the selected Vertical Format
command. This means you can instruct the printer to start
printing in line 4 with only one VCS command.
When using the second 3268 and 4214 emulations, you send the
commands below the interface. You can do this by transmitting
a file to the printer, or by entering the commands on your screen
and making a local copy (print screen). You can also do it using
shareport on the interface.
Remember
• This command adjusts with line feeds (LFs).
• This command is not supported for the 3287 emulation and
causes a line feed.
• All values, except channel one, must be specified before use;
otherwise, the VCS command is treated as a Line feed. If the
channel selected is less than or equal to the current page
position, the print position moves to the correct line on the
next page.
• Channel 1 is always top-of-form, while the other eleven
channels are taken as the first eleven tab stops from the Set
Vertical Format (SVF) command.
Vertical Tab (VT)
0B
Moves the print position vertically down to the next tab stop
setting, which is set by the Set Vertical Format command. If no
vertical tab stops are below the current print position, a vertical
tab results in a line feed. If a vertical tab is requested with the
print position below the bottom margin, it results in a move to
the top margin of the next page.
0B Control sequence of a Vertical Tab command
Remember This command adjusts with line feeds (LFs).
XEROX MRP FAMILY COAX COMMAND REFERENCE 2-21