Filter
Top Products
PREINSTALLATION
Note: To ensure the safety of the service representative during
maintenance and service of the equipment, the terminal must be
in the same room as the printer and in direct line of sight of the
printer.
Cable locations
To run the cables effectively beneath the flooring, it is necessary
to know where the cables enter and exit the printer and the
system controller. Figure 1-11 shows those locations (marked
with an X).
Figure 1-11. Cable enter/exit locations
Cable lengths
Cable lengths are important considerations in planning your LPS
layout, as components cannot be separated by more than the
recommended cable distances. The distances affect the
placement of the printer, system controller, and terminal.
Note: There are also distance requirements for some LPS
options. Consult with your sales or service representative for
these requirements.
Printer and system controller
Information on the cable lengths of the system controller and
printer follow:
• Printer and system controller can be separated by up to 25
ft/7.6 m.
• Printer is delivered with a 10 ft/3 m power cable.
• System controller is delivered with a 14 ft/4.3 m power cable
and a 50 ft/15.2 m interface cable.
1-20 XEROX 4050/4090/4450/4650 LPS INSTALLATION PLANNING