Filter
Top Products
Installation Planning Guide Safety notes
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX 2-11
• A wall panel circuit breaker, fuse, or other safety device has
been tripped.
• Liquid is spilled into the equipment.
• The equipment is exposed to water damage or flood.
• Any part of the equipment is physically damaged.
NOTE: The only method to remove all power from the printer is
to disconnect the power cable from the electrical outlet.
Printer - ozone information
This product produces ozone during normal operation. The
ozone produced is dependent on print volume and is heavier
than air. Install the system in a well ventilated room with the
minimum cubic size requirements listed below. Providing the
correct environmental parameter will ensure that the
concentration levels meet safe limits.
The minimum cubic volume requirement is: 1,765 cubic feet (50
cubic meters).
To determine if the room has the required volume to meet the
ozone requirement, the length of the room multiplied by its width
and height should be equal to or greater than the cubic volume
listed above.
If you need additional information about ozone, please request
the Xerox publication Ozone (part number 610P64653) by calling
1-800-828-6571 in the United States and Canada. In Xerox
Europe countries, call the local welcome center.
Printer - laser safety
CAUTION
The use of controls, adjustments or performance of procedures
other than those specified in this guide may result in hazardous
light exposure.
This equipment complies with international safety standards and
is certified as a Class 1 Product.