Filter
Top Products
4 Printer Operation
8265/8290/8365/8390 User Guide 85
Step 4 : Press the [F3] key or the [F4] key on the operation panel.
I) The product will perform following operations:
Setup items Key name Parameters Description
F3 Forward Feeds media forward. Cut & Feed
F4 Backward Feeds media backward.
Notes
If "Take-Up Roll" is set in the media detection setup menu, the product will not operate even if the [F4] key
has been pressed.
4.4.2 Controlling the Heater Elements
If you want to change or check the heater elements, follow the steps below.
Step 1 : Verify the following regarding the condition of the printer.
I) It is not currently printing
Step 2 : Press the [F3] key of the operation panel.
I) To shift to the heater menu.
The ‘heater message’ can be one of the following:
o Heater standby
o Heater warming up
o Heater ready
‘A’ stands for the heater.
‘B’ stands for the fixer.
‘C’ stands for the post fixer.
‘D’ stands for the dryer.
‘S’ stands for the Set-temperature (requested
temperature).
‘R’ stands for the Real-temperature (actual temperature).
4.4.2.1 Change
the heater temperature
To change the temperature of the heater, press the [F1] key on the operation panel. The display will
mention the following:
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.