Filter
Top Products
3-3
Step 2 : Mount the left side of the bars with the mounting supports to the printer’s stand as indicated on
the image below.
No. Description
1 Plain washer M6
2 Tooth lock washer M6
3 Hexagon bolt M6x12
Step 3 : Check the gap (s) between the adjustable mounting support (1) on the right hand side and the
printer stand and perform the correct action. This has to be done for both roll unit bars. See
below.
No Description
1 Adjustable mounting support
2 Left mounting support
3 Gap between support and printer foot
IF … THEN …
s = 1 or s > 1 mm
• loosen the 4 screws holding the support on the roll unit bar,
• slide the support against the right side of the printer’s stand,
• mount the support to the printer’s stand and fix the 4 screws holding the support
on the roll unit bar.
s < 1mm
• mount the support to the printer’s stand without adjusting.