Filter
Top Products
XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide 19
Document Properties Dialog (Job Tab Parameters)
FINISHING
Note: If you do not have a Finishing (.fin) File installed, "Folder bypass"
will be displayed in gray and any other options will be unavailable for
selection.
If you installed a Finishing (.fin) File from the "Select Finisher" option of
the Printer Properties dialog "Device Settings Tab," as stated in this User
Guide, the finishing drop-down list will be available for your selection.
You can use the drop-down list to select either Printer default or User
defined.
Printer Default uses the default finisher settings stored in the Controller,
previously set up using the Web Printer Manager Tool.
If you select User defined, the Settings… button will be enabled. When
you click this button, a Finishing Options dialog will display allowing you to
select the finishing program to use with your Finishing Device, override
features of the finishing program, select an output bin, and to let the
finisher know the location of the Title block in your document, if any. For
an explanation of the individual dialog features, click the "?" key in the
upper right corner of the dialog.
PLOT NESTING
This option allows you to determine if plot nesting will be applied to your
print job. The purpose of Plot Nesting is to efficiently group the printing of
plots on a single sheet of media to eliminate media waste. The factory
default setting is Off, however you can select either Printer default or
Single job as an option.
Printer Default uses the default plot nesting settings stored in the
Controller, previously set up using the Web Printer Manager Tool. These
pre-determined settings include: Exclusive nesting (i.e. reserved to a
Single Job), Timeout, Margins (between nested plots), and maximum
Nesting Length.
Single Job creates a plot nest restricted to the contents of your current
job. Plots from other job sources will not be intermixed with plots from
your job. If you select Single Job, the Settings… button will be enabled.
When you click this button, a Plot Nesting Options dialog will display
allowing you to adjust the margins between printed images on your
nested page.