Filter
Top Products
FORMS DESCRIPTION LANGUAGE
3-8 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS FORMS CREATION GUIDE
Specifying TAB as a form
To define a form to be used as a tab, specify the following:
PAPER [SIZE] [IS] 9 BY 11;
Refer to your
DocuPrint 96/DocuPrint 96MX LPS PDL Reference
for
a detailed explanation of the Ordered and Tab Stock feature.
Specifying non-standard sizes The format of the command for specifying nonstandard paper sizes
is as follows:
The x and y represent the decimal paper size that may be specified
if a form is to be printed on nonstandard size paper. Units are
optional. The default is inches.
Example:
PAPER SIZE IS USLETTER;
The DocuPrint 96/DocuPrint 96MX supports paper sizes of up to 17
by 14.33 inches by implementing a Short Edge Feed (SEF) scheme.
SEF refers to the direction the paper is fed when using paper sizes
larger than 14.33 inches in length. This feature enables you to print
paper size up to 17 by 14.33 inches while retaining the current
definition of landscape and portrait orientation. Refer to your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference
for
additional information on the SEF capability.
With predefined formats If a predefined format is specified in the GRID command, paper size
is determined automatically, and the PAPER command is
unnecessary. The PAPER command is required, however, any time
the paper size is different from the sysgen default.
Default paper size If no PAPER command is present, and no predefined format is
specified, the sysgen-defined paper size in effect at run time is used
as the form’s paper size value.
Caution: The correct size paper must be loaded in the feeder. A
paper size mismatch at run time causes an error message to be
displayed. The form does not print, and the job may be aborted.
PAPER [SIZE] INCHES
CM
CENTIMETERS
DOTS
XDOTS
x
[BY] y INCHES
CM
CENTIMETERS
DOTS
XDOTS