Filter
Top Products
FUSER LUBRICANT
3-4 XEROX DOCUPRINT 96/4635/180 IPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
!
Warning: If any fuser agent spills on the floor, remove it
immediately. Fuser agent spills make the floor slippery. Use of
Xerox Film Remover (isopropyl alcohol) is recommended to
clean up spills.
Caution: The fuser reservoir has an anti-splash seal. Do not
push the fuser agent bottle into the reservoir with excessive
force, as this can damage the seal.
7. Replace the reservoir cap by turning it clockwise and push the
fuser agent reservoir in until it stops.
8. Push the fuser drawer in until it latches in place.
9. Dispose of the dropcloth and any empty agent bottles in a trash
receptacle. If there is any agent left in the bottle, cap the bottle
and store it for future use.
10. Remove and dispose of the gloves in a trash receptacle, being
careful not to let any residue come in contact with your skin.
11. Close the printer doors.
Note: The fuser agent message disappears after the printer
prints between 32 and 40 sheets. Since the sheets must be
processed continuously, you may want to run 45 test pages in
order to clear the message from the system (unless the current
print job contains at least 40 pages).
12. Wash your hands to remove any fuser agent.