Filter
Top Products
XEROX DOCUPRINT 96/4635/180 IPS GUIDE TO PERFORMING ROUTINE MAINTENANCE 6-1
6. 6Cleaning
This chapter describes the cleaning tasks you need to perform
regularly on the 96/4635/180 IPS printer.
Cleaning the keyboard, monitor, and the exterior of the Printer Controller
Clean the exterior surfaces of your Printer Controller, including
monitor and keyboard, as required. Clean daily, if possible.
Use the following supplies to clean the exterior surfaces:
• Monitor: Use a soft, lint-free cloth dampened with a glass
cleaner. Do not spray the liquid directly onto the monitor, it may
cause damage.
• Keyboard: Use a mild household detergent that has been
poured or sprayed onto a cloth lightly dampened with water. Do
not saturate the cloth; just dampen it.
• Exterior: Use a mild household detergent that has been poured
or sprayed onto a cloth lightly dampened with water. Do not
saturate the cloth; just dampen it.
Caution: Do not allow liquids to drip onto anything electrical or
mechanical. For the same reason, never spray or pour the cleaner
directly onto the keyboard or the exterior surfaces of the system.
Cleaning the sensors and the reflective surfaces
Sensors at various points along the paper path indicate where sheets
of paper are passing. After a sheet has passed a sensor, if too much
time elapses before another sheet arrives, the system determines a
jam has occurred, and printing stops. If a sensor becomes dirty, it
may not accurately detect sheets passing and may give incorrect jam
information. Therefore, it is important to clean sensors regularly.
Sensors are usually cleaned by your Xerox service representative as
part of regular maintenance. However, under certain conditions you
may be directed to clean them yourself by the Xerox Customer
Support Center or by your local operating company.
1. Brush or wipe the sensor window lightly with a lint-free cloth,
cleaning pad, or cotton swab.
Note: If the sensor is very dirty, use a small amount of alcohol
on the swab.
2. Remove any paper dust present in the area.
Caution: Do not use any abrasives or strong solvents on the
sensors.