Filter
Top Products
Copying
4.
2
3
Press button to save the selection.
Changing the default settings
The copy options, including darkness, original type, copy size
and number of copies, can be set to the most frequently used
modes. When you copy a document, the default settings are
used unless they are changed by using the menus on the
control panel.
To create your own default settings:
1
Press button until
Copy Setup
appears on the top line
of the display.
2
Press
OK
when
Default-Change
appears.
3
Press the scroll button ( or ) to select a setup option
and press button.
4
Press the scroll button ( or ) to change the setting or
enter the value and press button.
5
Repeat steps 3 through 4, as needed.
6
Press button
to return to Standby mode.
NOTE
: While you are setting copy options, pressing
button cancels the changed settings and restores their default
status.
Using special copy features
Clone copying
This feature prints multiple image copies from the original
document on a single page. The number of images is
automatically determined by the original image and paper size.
1
Place the document to be copied on the document glass,
and close the cover.
2
Press button
until
Special Copy
appears on the top
line of the display.
3
Press the scroll button ( or ) until
Clone
appears and
press button.
4
Customize the copy settings including copy size, darkness,
and original type, by using the control panel buttons. See
page 4.1.
NOTE
: You cannot adjust the copy size using the
Reduce/
Enlarge
menu while making a clone copy.
5
Press button to begin copying.
Auto Fit copying
This feature automatically reduces or enlarges the original
image to fit on the paper currently loaded in the machine.
NOTE
: When the size of the document you want to copy is not
same as the size of the paper loaded, this function
automatically adjusts the size of the document to fit the paper.
You can not adjust the copy size manually.
1
Load the document to be copied on the document glass,
and close the cover.
2
Press button
until
Special Copy
appears on the top
line of the display.
3
Press the scroll button ( or ) until
Auto Fit
appears and
press button.
4
Customize the copy settings including copy size, darkness,
and original type, by using the control panel buttons. See
page 4.1.
NOTE
: You cannot adjust the copy size using the
Reduce/
Enlarge
menu while Auto Fit copying is enabled.
5
Press button to begin copying.
ID Card copying
You can copy both sides of the ID Card like a drivers licence to
a single side of paper.
When you copy using this feature, the machine prints one side
of the card on the upper half of the paper and the other side on
the lower half without reducing the size of the original.
If the loaded card is larger than the printable area, some
portions may not be printed.
1
Place the ID Card to be copied on the document glass and
close the cover.
2
Press button
until
Special Copy
appears on the top
line of the display.
3
Press the scroll button ( or ) until
ID Card copy
appears and press button.
4
Customize the copy settings including copy size, darkness,
and original type, by using the control panel buttons. See
page 4.1.
5
Press button to begin copying.
Your machine begins scanning the front side and will then
display
Set Backside
.
6
Open the document cover and flip the document over.
Close the cover.
A