Filter
Top Products
XiNCOM Corp.
Policy Configuration
When you use Qo
to pass through.
S, you must define some policies to make some packets to have higher priority
Figure 33: Policy Configuration.
Data – Policy Configuration.
Network
Policy
This section identifies each policy
licy Name List – When adding a new Policy, ignore this list. To edit an
utton. The data
• ddress – Define the destination address of packets here. The
• ,TCP and UDP.
• Source Port – Define the source port of packets here.
• Destination Port – Define the destination port of packets here.
• Priority Queue – It defines a packet if it meets all conditions defined above, it
will be serviced with some priority level.
Admission
• Po
existing entry, select it from the list, and click the "Select" b
fields will then be updated with data for the selected entry.
• Policy Name – Enter a suitable name. Generally, you should use the "Policy
Name" for the network traffic.
• Source Address – Define the source address of packets here. It has two
types like IP address or MAC address. If you select IP address, you can
define IP address range, otherwise define up to four MAC addresses.
Destination A
explanation is as the same as above.
Protocol Type – The field defines traffic packet type, i.e. IP
Page 53