Filter
Top Products
E-34
Additional information
Message
No Signal
INPUT A (Component) (Example)
Out Of Range
Unknown Format
Auto Sync...
Memory 1—6
The lamp needs to be replaced. Please
replace the lamp you are currently
using with a new one.
Press again for standby.
Squeeze (Example)
Lens Adjustment is locked.
■ Message display
Condition
The unit is not receiving or detecting any signal at the selected input source. This message is displayed
together with the name of the input source selected with the INPUT button.
The input name selected by the INPUT button is displayed. It will turn off 1 minute after the signal has
been input.
The unit is not able to decode the PC signal currently being input.
The unit is not able to decode the video signal currently being input.
The unit is setting itself to the most appropriate configuration for the RGB signal currently being received.
The memory setting number is displayed for 2 seconds.
This message is displayed when the power switch is turned on if the lamp running time exceeds 2000 hours.
Press the ESCAPE key to remove the message.
Press the STANDBY/ON button once more to place the unit in standby mode.
The name of the display aspect mode selected with the ASPECT button is displayed for 2 seconds.
Displayed when the “LENS ADJUSTMENT LOCK” is set to “ON”. This message will display for 2
seconds if you press the V.POS, ZOOM, or FOCUS buttons when the “LENS ADJUSTMENT LOCK” is
set to “ON”.