Filter
Top Products
5
Introduction
Getting Started
Using the
Printer
Troubleshooting
Contact Us
P4T/RP4T
Quick Start Guide
Load the Media
Section Continues
1. Open the Media Cover
Press down on the Media
Cover Latch Lever
2. Load the Media Roll
Pull Media Supports
apart where shown.
Load Media Roll
Note direction media pulls off the roll.
Always ensure you are using the correct me-
dia. Use RFID media only in RP4T printers.
3. Close the Media Cover
Close Media Cover
Media cover opens
4. Insert Media into Peeler
Optional Step for label stock only
Pull Media out of the Printer.
Use alignment marks on the
cover to ensure alignment.
3. Feed the leader over
the peeler bar and into
the printer.
4. Press down on Peeler
Assembly where shown
and slide the media until it
emerges .
Peeler Bar.
2. Align the edge of the leader
with the index marks on the
top cover to ensure it will pass
through the peeler without
wrinkling.
Peeler Assembly.
1. Remove enough
labels from the me-
dia roll to create a 4”
[100 mm] leader.