Filter
Top Products
3
Introduction
Getting Started
Using the
Printer
Troubleshooting
Contact Us
P4T/RP4T
Quick Start Guide
UCLI72-4 Quad Charger
The UCLI72-4 uad Charger is an optional accessory kit allowing simultaneous charging of up to four battery packs.
The UCLI72-4 Quad Charger is designed to charge
up to four battery packs simultaneously. Charging
time is as follows:
Battery Status Charging
Time
80% charged 2.5 Hrs.
Full charge 5 Hrs.
Plug a battery pack into any one of the four charg-
ing bays as shown opposite, noting the orientation
of the battery pack. Slide the battery pack into the
charging bay until it stops. Then rock the battery
pack back until it snaps into place. The amber indi-
cator directly under the battery pack being charged
will turn on if the battery pack is properly inserted.
The indicators under each battery pack will allow
you to monitor the charging process per the table
below:
Amber Green
Battery Status
On Off Charging
On Flashing
80% charged
(O.K. to use)
Off On
Completely
Charged
Flashing Off Faulty battery
pack
Section Continues
Fault
Fast Charge
Fault
Fast Charge
Fault
Fast Charge
Ready
Power
Full Charge
Ready
Full Charge
Ready
Full Charge
Full Charge
Fault
Fast Charge
Ready
For more information refer to the instructions included with the UCLI72-4 Quad Charger, or to the more detailed discussion of the quad
charger in the P4T/RP4T User Guide.
The UCLI72-4 Quad Charger has a safety feature which stops charging after six hours regardless of the battery pack’s charge state.
Charger Bay
Amber
Indicator
Green
Indicator
Power
Indicator
Power Supply
1. Slide Battery
Pack into a Char-
ger bay
2. Rock Bat-
tery Pack into
place