Filter
Top Products
2. Separate and hold open the media hangers (refer to Figure 9).
3. Place the media roll onto the media hangers, making sure it is tightly
wound(refertoFigure10).
4. Open the peel-off unit by pulling down on its textured top surface (refer
toFigure11).
5. Activate the peel-off unit by moving the peel-off switch to the left
(refertoFigure11inset).
NOTE: When not operating the printer in peel-off mode, always
deactivate the peel-off unit by moving the peel-off switch to the
right.
6. Remove approximately 6” (152 mm) of labels from the label backing.
10
Media
Hanger
Media
Hanger
Figure 9