Proprietary Statement
This manual contains proprietary information of Zebra Technologies Corporation. Itis intended solely for the information and
use of parties operating and maintaining the equipment described herein. Suchproprietary information may not be used,
reproduced, or disclosed to any other parties for any other purpose without the expressed written permission of Zebra
Technologies Corporation.
Product Improvements
Continuous improvement of products is a policy of Zebra Technologies Corporation. Allspecifications and signs are subject
to change without notice.
FCC Compliance Statement
NOTE: Thisequipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. Theselimits are designed to provide reasonable protection against harmful interference in a residential
installation. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee
that the interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
n
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and the receiver.
n
Connect the equipment into an outlet on a circuit different than that to which the receiver is connected.
n
Consult the dealer or an experienced Radio/TV technician for help.
NOTE: This unit was tested with shielded cables on the peripheral devices. Shieldedcables must be used with the unit to
insure compliance.
“The user is cautioned that any changes or modifications not expressly approved by Zebra Technologies Corporation could
void the user’s authority to operate the equipment.”
Canadian DOC Compliance Statement
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the radio
interference regulations of the Canadian Department of Communications.
Liability Disclaimer
Zebra Technologies Corporation takes steps to assure that its published Engineering specifications and Manuals are correct;
however, errors do occur. ZebraTechnologies Corporation reserves the right to correct any such errors and disclaims liability
resulting therefrom.
No Liability for Consequential Damage
In no event shall Zebra Technologies Corporation or anyone else involved in the creation, production, or delivery of the
accompanying product (including hardware and software) be liable for any damages whatsoever (including, without limitation,
damages for loss of business profits, business interruption, loss of business information, or other pecuniary loss) arising out of
the use of or the results of use of or inability to use such product, even if Zebra Technologies Corporation has been advised of
the possibility of such damages. Becausesome states do not allow the exclusion or limitation of liability for consequential or
incidental damages, the above limitation may not apply to you.
Copyrights
This copyrighted manual and the label printer described herein are owned by Zebra Technologies Corporation. Allrights are
reserved. Unauthorizedreproduction of this manual or the software in the label printer may result in imprisonment of up to
one year and fines of up to $10,000 (17 U.S.C.506). Copyrightviolators may be subject to civil liability.
All products and brand names are trademarks of their respective companies. Allrights reserved.
© 1999 Zebra Technologies Corporation