Filter
Top Products
Fanfold Media
Fanfold media loads from the outside of the printer. Refer to Figure 18.
1. Thread the media through the access slot in the back of the printer.
2. Separate and hold open the media hangers.
3. Lock the media hangers in position by tightening the screw located on
the right media hanger.
CAUTION: Do not overtighten the screw! Overtightening
could pierce the case and damage the printer’s electronics!
4. Thread the media through the media guides.
NOTE: If the media guides must be changed to accommodate the
width of the media, turn the green media guide adjuster. Media
guides should just touch, but not restrict, the edges of the media.
5. Close the top cover and turn on the printer or press the feed button if
theprinterisalreadyon(see“AutoCalibration”onpage18formore
information).
17
Media
Hangers
Media
Guides
Media
Guide
Adjuster
Lock-down
Screw
Access
Slot
Figure 18