Filter
Top Products
168
Appendix A
Regulatory information
FCC Warning
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. Caution: For the purpose of satisfying FCC RF exposure compliance requirements,
antennas should be positioned in such a way that a separation distance of at least 20cm is maintained between the
transmitter's radiating structures and the body of the user or nearby persons.
FCC Part 15 Emissions Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
−
Reorient or relocate the receiving antenna.
−
Increase the separation between the equipment and receiver.
−
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
−
Consult the dealer or an experienced radio/TV technician for help.
Department of Commerce End User Statement
This item falls under the jurisdiction of the Department of Commerce, and as such, the requirement set forth in section 740-
17 of the Export Administration Regulation must be complied with. See the following Web sites for more information:
Bureau of Export Administration
http://www.bxa.doc.gov/DPL/Default.shtm
http://www.bxa.doc.gov/Entities/
A