Filter
Top Products
Chapter 19 Log Screens
NWA-3500/NWA-3550 User’s Guide
242
19.4.2 Log Commands
Go to the command interpreter interface (refer to Appendix E on page 357 for a
discussion on how to access and use the commands).
19.4.3 Configuring What You Want the NWA to Log
Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the NWA is to record.
Use sys logs category followed by a log category and a parameter to decide what to
record
Use the sys logs save command to store the settings in the NWA (you must do this in
order to record logs).
19.4.4 Displaying Logs
Use the sys logs display command to show all of the logs in the NWA’s log.
Use the sys logs category display command to show the log settings for all of the log
categories.
Use the sys logs display [log category] command to show the logs in an individual
NWA log category.
Use the sys logs clear command to erase all of the NWA’s logs.
Table 76 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
error 0, 1, 2, 3
mten 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that
category.