Filter
Top Products
Prestige 128IMH ISDN Modem/ Router/Hub
8-8 Dial-In Server Configuration
8.3.1 Default Dial-in Filter
Use Menu 13.1 – Default Dial-in Filter to specify the filter set(s) to apply to the incoming
and outgoing traffic between all dial-in users and your Prestige. Note that the filter set(s) only
applies to the dial-in users but not the remote nodes. You can specify up to 4 filter sets
separated by comma, e.g., 1, 5, 9, 12, in each of the filters field. The default is no filters.
Spaces are accepted in this field. For more information on defining the filters, see Chapter 9.
Figure 8-4 Default Dial-in Filter
8.4 Dial-In Users Setup
The following steps describe the setup procedure for setting up a remote dial-in user.
Step 1. From the Main Menu, enter option 14 to go to Menu 14 - Dial-in User Setup, as
shown in the figure below.
Figure 8-5 Menu 14 - Dial-in User Setup
Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=