Filter
Top Products
Prestige 128IMH ISDN Modem/ Router/Hub
5-4 Remote Node TCP/IP Configuration
The following table shows the TCP/IP related fields in Menu 11.3 - Remote Node Network Layer
Options.
Table 5-2 TCP/IP Remote Node Configuration
Rem IP Address This will show the IP address you entered for this remote node
in the previous menu.
Rem IP Subnet
Mask
Enter the subnet mask for the remote network.
My WAN Addr Some implementations, especially the UNIX derivatives,
require the ISDN link to have a separate IP network number
from the LAN and each end must have a unique address within
the WAN network number. If this is the case, enter the IP
address assigned to the ISDN port of your Prestige.
Note that this is the address assigned to your local Prestige,
not the remote router.
Single User
Account
Set this field to Yes to enable the Single User Account feature
for your Prestige. Use the space bar to toggle between Yes
and No. See Chapter 3 - Internet Access Application for more
information on the Single User Account feature.
Yes/No
Metric The metric represents the “cost” of transmission for routing
purposes. IP routing uses hop count as the measurement of
cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and 15.
In practice, 2 or 3 is usually a good number.
1 to 15
Private This parameter determines if the Prestige will include the route
to this remote node in its RIP broadcasts. If set to Yes, this
route is kept private and not included in RIP broadcast. If No,
the route to this remote node will be propagated to other hosts
through RIP broadcasts.
Yes/No
RIP Press the space bar to select the RIP direction from Both/In
Only/Out Only.
(Default=Both)
Version= Press the space bar to select the RIP version from RIP-1/RIP-
2B/RIP-2M.
RIP-1 (default)