Filter
Top Products
Prestige 128IMH ISDN Modem/ Router/Hub
4-10 Remote Node Configuration
Add Persist This parameter specifies the number of seconds
where traffic is above the adding threshold before
the Prestige will bring up the second link.
Default = 5
sec
Subtract Persist This parameter specifies the number of seconds
where traffic is below the subtraction threshold
before your Prestige drops the second link.
Default = 5
sec
Once you have completed filling in Menu 11.2 - Remote Node PPP Options, press [Enter] at the
message [Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to
cancel.
4.1.7 Remote Node Filter
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and
outgoing traffic between this remote node and the Prestige and to prevent certain packets from
triggering calls. You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each of
the filters field. The default is no filters.
Note that spaces are accepted in this field. For more information on defining the filters, see
Chapter 9. The Prestige comes with a prepackaged filter set, NetBIOS_WAN, that blocks
NetBIOS packets. You can include this in the call filter sets if you wish to prevent NetBIOS
packets from triggering calls to a remote node.
Figure 4-4 Menu 11.5 – Remote Node Filter
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=