Filter
Top Products
Chapter 2 The WPS Button
FSG1100HN User’s Guide
18
Off
The FSG1100HN’s power is off, it is in
bridged mode, or a connection not present.
Red
On
The FSG1100HN’s attempt to achieve an IP
connection failed (no DHCP response, no
PPPoE response, PPPoE authentication
failed, no IP address from IPCP, etc.).
LAN 1-4
Green
On
The FSG1100HN has a successful
10/100Mbps Ethernet connection.
Blinking
The FSG1100HN is sending/receiving data
through the LAN, flashing at 4 HZ with a 50%
duty cycle.
Off
The LAN is not connected or the FSG1100HN
is powered off.
WPS
Button
Press this button for 1 second to set up a wireless connection via
WiFi
Protected Setup with another WPS-enabled client. You must press
the
WPS button on the client side, holding the button for at least 5
seconds, for a successful connection.