Filter
Top Products
Chapter 6 Wireless LAN
WRE2205 User’s Guide
46
Figure 34 Network > Wireless LAN > AP Select
The following table describes the labels in this screen.
Table 18 Network > Wireless LAN > AP Select
LABEL DESCRIPTION
Select Use the radio button to select the wireless device to which you want to connect.
SSID This displays the Service Set IDentity of the wireless device. The SSID is a unique name
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
MAC This displays the MAC address of the wireless device.
Channel This displays the channel number used by this wireless device.
Mode This displays which IEEE 802.11b/g/n wireless networking standards the wireless device
supports.
Security Mode This displays the type of security configured on the wireless device. When no is shown, no
security is configured and you can connect to it without a password.
Strength This displays the strength of the wireless signal. The signal strength mainly depends on
the antenna output power and the distance between your WRE2205 and this device.
Setup repeater
manually
Select this to setup the AP manually.
SSID If Setup repeater manually is selected, use this field to type the SSID of the AP. This is
useful when the AP’s SSID is hidden.
Refresh Click this to search for available wireless devices within transmission range and update
this table.
Previous Click this to see the previous page of APs.
Next Click this to see the next page of APs.
Apply Click this to start the next step in the AP setup process.