Services Menu
Table 8 shows the Services menu.
Table 8. Services
Function Next Menu
Cancel “Options Menu” on page 31
Set Online. “Set Online Menu” on page 35
Set Offline. “Set Offline Menu” on page 36
Set Address... (SCSI
Attached Drives
Only)
“Set Address Menu” on page 37
Fibre Address...
(Fibre Attached
Drives Only)
“Fibre Address Menu” on page 40
Change Language... “Change Language Menu” on page 45
Statistics... “Statistics Menu” on page 46
Refresh Tape —
Microcode Level Figure 10 on page 34, then after selection, to “Services Menu”
Reset Drive Figure 11 on page 35, then after selection, to “Services Menu”
Force Error Dump Figure 11 on page 35, then after selection, to “Services Menu”
Note: Supplemental Message Lines: <none>
Cancel
Causes the “Options Menu” on page 31 to appear.
Set Online
Logically enables the device to communicate on the SCSI bus. Activate
Set Online at the device first, then have the host place the device
online (vary online).
Set Offline
Logically disables the device from the SCSI bus. Select Set Offline only
after the host has taken the device offline (vary offline) first.
Set Address
Provides the two SCSI addresses to be selected; one address that is
associated with each device interface. Each address consists of one
hexadecimal digit that specifies the SCSI address for that interface.
After the address is set, change the host information to include the
correct addresses.
Fibre Address
Provide the two Fibre Arbitrated Loop Physical Addresses (AL_PA) to
be selected; one address that is associated with each device interface.
Chapter 3. Drive Operator Panel and Controls 33
