Filter
Top Products
5-2 CHAPTER 5: CONFIGURING THE TR-IN-FE MODULE
Setting Up a Module
The Module Configuration Screen displays the set-
tings used by the TR-in-FE Module to communicate
with other devices on the network.
It is unlikely that you will need to change the value of
these settings once they have been set.
CAUTION: If you need to change the value of any of
the settings, you may experience a temporary loss of
communication while the values are reset. If you do
not need to make any changes, select the CANCEL
button and not the OK button. Selecting the OK
button resets the device.
To configure a module, log on to the Switch 2000 TR
and proceed as follows:
1 Select SWITCH MANAGEMENT from the Main Menu.
2 Press [Space Bar] and select *I/O Module*.
The I/O Module screen appears. The I/O Module
screen allows you to view statistics and set up the
TR-in-FE module. See Figure 5-2.
If the I/O Module option does not respond, your
TR-in-FE module is not installed correctly. Refer to
Chapter 3 for information on installation.
3 Enter the *Unit ID* of the unit with the module
installed.
4 Select SETUP.
Figure 5-2 I/O Module Screen (CONFIG)
5 Press [Return].
The Port Setup screen appears. See Figure 5-3.
Figure 5-3 Port Setup Screen