A-16 APPENDIX A: CLI COMMAND DESCRIPTION
show adsl statistics Displays block count statistics for the ADSL interface. It reports the number of
blocks transmitted and received. It also reports the number of blocks received with
corrected errors, and the number received with uncorrectable errors.
show adsl
transceiver_status
Displays the current status of the ADSL transceiver. It lists:
■ Operational Mode – Current operational mode of the transceiver.
■ Attenuation – the difference in dB between transmitted and received signal
power.
■ Signal to Noise Ratio Margin – the SNR margin required by the transceiver
to maintain the ADSL link.
■ Transmit Power - The transmit power in dB of the local ADSL transceiver.
■ Code Word Length – The current code word size for the fast interlayed paths.
■ Downstream Rate – the negotiated bit rate for data received from the
network.
■ Upstream Rate – the negotiated bit rate for data transmitted to the network.
show adsl version Displays version information about the ADSL interface. It lists:
■ Hardware Release Version - Version of the ADSL chipset present on the unit.
■ Firmware Release Version - Version of the ADSL firmware present on the
unit.
show atm status Displays current statistics for the ATM protocol running over the ADSL WAN
interface. It lists:
■ Cell Delineation - Whether or not cell delineation is currently achieved.
■ RX No Pkt Avail - Number of times a packet was reassembled but could not
be delivered over the LAN because of lack of packet memory within the
HomeConnect ADSL Modem.
■ RX Bad VPI or VCI - Number of ATM cells received with a bad or inactive VPI
and/or VCI number.
show bridge settings Displays the settings for all bridge networks. Use set bridge to modify these values.
■ Base Aging Time - time to age out a known MAC address, default 300
■ Spanning Tree Forward Delay - delay after coming up before learning,
default is 15
■ Spanning Tree Priority - this bridge’s bid to be root bridge, default is 32768
■ Access MACs Only - This can be enabled or disabled.
■ Spanning Tree Mode - sets spanning tree algorithm on. Default is DISABLED
■ Base MAC Address - address of the bridge
■ Number of Networks - number of networks in this bridge