3M 11-81375-227 Computer Monitor User Manual


 
18 3M™ MicroTouch™ Display M1500SS User Guide
3M Touch Systems, Inc. Proprietary Information
Connecting the Display
CAUTION
You are cautioned that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your authority to operate
such equipment.
To connect the M1500SS Display:
1.
Turn off your computer. You should always turn off the computer before connecting
or disconnecting any device.
2.
Connect one end of the video cable to the video connector on the display. Connect
the other end to the video card in your computer.
3.
Connect one end of the touch sensor cable (either serial or USB) to the display.
Connect the other end to an available port on the back of your computer. If you are
using a USB connection, make sure you have installed the Touch Software drivers
prior to connecting the touch sensor cable.
4.
Plug the AC/DC power supply into the M1500SS Display. Be sure to use the power
supply included with the display.
Figure 9 Identifying Your Display Connections
WARNING
To avoid the risk of electric shock which could result in serious injury or death:
This device must be operated with the original power supply, part numbers
HJC - HASU05F
AC Adapter – STD1203
Li Shin – LSE9901B1250
CHI -- CH-1234.
Video Connection
Power
Micro
p
hone out
Touch Senso
r
Line In